Reported-by: Dan Carpenter <error27@gmail.com>
Signed-off-by: Marcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Unset the bit that indicates that a ctxprog can continue at the end.
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

ramfc is zero'ed upon destruction, so it's safer to do things in the right
order.
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

- We need to disable pgraph fifo access before checking the current channel,
  otherwise we could still hit a running ctxprog.
- The writes to 0x400500 are already handled by pgraph->fifo_access and are
  therefore redundant, moreover pgraph fifo access should not be reenabled
  before current context is set as invalid. So remove them altogether.
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

- In the current situation the padding that is added is dangerous to write
  to, userspace could potentially overwrite parts of another bo.
- Depth and stencil buffers are supposed to be large enough in general so
  the waste of memory should be acceptable.
- Alternatives are hiding the padding from users or splitting vram into 2
  zones.
Signed-off-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Fixes DVI+VGA on my 9400, and likely a lot of other configurations that
got broken by the previos DVI-over-DP fix.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

With DVI and DP plugged, the DVI clock change interrupts being run can
cause DP link training to fail.  This adds a spinlock around init table
parsing to prevent this.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Writes don't return a count, and adding the check broke native DP.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

It appears we aren't required to do memory sizing ourselves on nv40
either.  NV40 init tables read a strap from PEXTDEV_BOOT_0 into a
CRTC register, and then later use that value to select a memory
configuration (written to PFB_CFG0, just like INIT_COMPUTE_MEM on
earlier cards) with INIT_IO_RESTRICT_PROG.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

We used single shared fbops struct and patched it at fb init time with
pointers to the right variant. On mixed multicard, this meant that
it was either sending NV50-style commands to all cards, or NV04-style
commands to all cards.
Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Test the just-allocated value for NULL rather than some other value.

The semantic patch that makes this change is as follows:
(http://coccinelle.lip6.fr/)

// <smpl>
@@
expression x,y;
statement S;
@@

x = \(kmalloc\|kcalloc\|kzalloc\)(...);
(
if ((x) == NULL) S
|
if (
-   y
+   x
       == NULL)
 S
)
// </smpl>
Signed-off-by: Julia Lawall <julia@diku.dk>
Cc: David Airlie <airlied@linux.ie>
Cc: Ben Skeggs <bskeggs@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

nouveau_gem_ioctl_cpu_prep calls ttm_bo_wait without the bo lock held.
ttm_bo_wait unlocks that lock, and so must be called with it held.

Currently this bug causes libdrm nouveau_bo_busy() to hang the machine.

Signed-off-by: Luca Barbieri <luca at luca-barbieri.com>
Acked-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Apparently, they generate a PFIFO interrupt each time one of the
semaphore methods is executed if its ctxdma wasn't manually marked as
valid. This patch makes it flip the valid bit in response to the
DMA_SEMAPHORE method (which triggers the IRQ even for a valid ctxdma).
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

On nv50, this will be needed by applications using CUDA to know
how much stack/local memory to allocate.
Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

noaccel=1 disables all acceleration and doesn't even attempt
initialising PGRAPH+PFIFO, nofbaccel=1 only makes fbcon unaccelerated.
Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Due to a thinko, these were previously forced to VRAM even if we allocated
them in GART.

This commit fixes that bug, but keeps the previous behaviour of using VRAM
by default until it's been tested properly across more chipsets.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Another hack because of us exposing each encoder block's function as
an encoder rather than exposing a single encoder that deals with them
all.

A proper fix will come, it's just rather invasive so this hack will
do until then.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

We need to add the buffer to the list even if we fail, otherwise the
validate_fini() call won't unreserve + unreference the GEM object,
making TTM very unhappy.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Also adds a module option to ignore the status reported via ACPI, in case
we hit systems with broken ACPI.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

On most cards the DisplayPort connector is created with 2 encoders sharing
a single SOR (for native DP, and for DVI-over-DP).  The previous logic
for turning off unused encoders didn't take into account that we could
have multiple drm_encoders on a single hw encoder and ended up turning off
encoders that were actually being used still.

This patch fixes that issue.  We probably want to look at something a bit
better later on, and only expose one drm_encoder per hw encoder block.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

GPU pointer to the structure is shifted right by 10 bits, so we need to
align to 1024 bytes, not 256.
Reported-by: Maarten Maathuis <madman2003@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Currently, we take down the sgdma engine without evicting all buffers
from VRAM.

The TTM device release will try to evict anything in VRAM to GART
memory, but this will fail since sgdma has already been taken down.

This causes an infinite loop in kernel mode on module unload.
It usually doesn't happen because there aren't any buffer on close.
However, if the GPU is locked up, this condition is easily triggered.

This patch fixes it in the simplest way possible by cleaning VRAM
right before cleaning SGDMA memory.
Signed-off-by: Luca Barbieri <luca@luca-barbieri.com>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Currently Nouveau is unable to dismiss DMA_VTX_PROTECTION errors,
which results in an infinite loop in the interrupt handler.

These errors are caused both by bugs in the Gallium driver and by
user-specified index buffers with out of bounds indices.

By mmio-tracing the nVidia drivers, I found out how this is done.
On DMA_VTX_PROTECTION, The nVidia driver reads the register 0x402000,
always getting the value 4, and then writes 4 back to 0x402000.

This patch adds that logic by reading 0x402000 and writing the same
value back.
It's unclear what should happen if the value read is not 4, and
the current approach might not be the correct one.

To test this, modify mesa/progs/trivial/vbo-drawrange.c, defining
ELTOBJ to 1 and replacing indices with huge out of bounds integers.

Without this patch, the GPU and/or kernel should lock up.
With this patch, it should misrender as expected but not lock up.

The errors are still logged since they are useful for development.

This has been tested on NV49 and may not work on other cards.

To find out how things work on other cards, run the aforementioned
test using the blob with mmiotrace and grep for a read of the PGRAPH
source register.
Signed-off-by: Luca Barbieri <luca@luca-barbieri.com>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Can be triggered easily on certain cards (NV46 and NV50 of mine) by
running "dmesg", the DRM's channel will lockup.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Currently there is no check that the pushbuffer request bounds are inside
the TTM BO.

This allows to instruct the kernel to do relocations on user-selected
addresses, since the relocation bounds checking relies on the request
bounds.

This can oops the kernel accidentally and is easily exploitable.

This patch adds bound checking and alignment checking for ->offset and
->nr_dwords.

It also makes some variables unsigned, which should have no effect,
but prevents possible bounds checking problems.
Signed-off-by: Luca Barbieri <luca@luca-barbieri.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

This is to prevent things such as GART tables and other important GPU
structures being allocated there before we take over fbcon ourselves.

This is more of a workaround for the moment, a better solution will
require some more invasive changes, but it'll be done at some point.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

This was spotted by kmemleak.
Signed-off-by: Xavier Chantry <shiningxc@gmail.com>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

This fixes imac black screen (NV18 card)
Signed-off-by: Andrea Tacconi <tacconet@libero.it>
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

This enables streamout functionality.
Signed-off-by: Marcin Kościelnicki <koriakin@0x04.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

This in the very least matches the parsing of all the previously known
entries, and hopefully (at least closer to) correct for any we haven't
seen yet.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

There's a report of a TNT2 where the DCB table pointer is *not* NULL
(it contains a part of a VBIOS data string), and we assume this means
a DCB table is present, causing all kinds of hilarity.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

We don't setup PRIV0 anymore, so this is unnecessary.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Not an ideal solution, but it'll do for the moment for correctness.  We
need to come up with a nicer way to manage inter-channel sync, the hw
is unfortunately a little lacking in this area.

Should fix some resume corruption, as well as corruption that may be seen
while under memory pressure.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

Apparently the original reason for checking this was there were known
register accesses that caused hangs on some chipsets.  This was more
than likely because of incorrect parsing of previous opcodes, and I
hardly think aborting a script half way through is going to be any
better (in fact, we have had bug reports where this has been the cause
of s/r failures among other things).

This patch (which has been in Fedora 12 for a long time now) removes
all checking for known register ranges, and just leaves the check to
ensure the access is within the mapped aperture to avoid an oops.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>