- 01 Sep, 2010 13 commits
-
-
Yaniv Rosner authored
In BCM8727 based boards, setting default 10G link speed after link was set to 1G may lead to link down issue. The problem was setting the right value, but to the wrong registers Signed-off-by:
Yaniv Rosner <yanivr@broadcom.com> Signed-off-by:
Eilon Greenstein <eilong@broadcom.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Yaniv Rosner authored
Fix potential link issue caused by insufficient delay time during SPIROM load of BCM8073/BCM8727 Signed-off-by:
-
Amit Kumar Salecha authored
o New CKSUM flag added by fw to notify cksum is verified. o Update version to 5.0.9 Signed-off-by:
Amit Kumar Salecha <amit.salecha@qlogic.com> Signed-off-by:
-
Amit Kumar Salecha authored
Hypervisor allows, two VM's interfaces to have same mac address. These VM's interfaces get differentiate with Vlan tag. This patch add support to learn and configure mac+vlan filter on device. Signed-off-by:
-
Amit Kumar Salecha authored
Device eswitch need to configure with VM's mac address. Hypervisor doesn't provide any utility/callbacks to get VM's mac address. Unicast mac address filter improves performance and also provide packet loopback capability i.e communication between VM. Above features is by default off, can be turned on with module parameter 'mac_learn'. Signed-off-by:
-
Rajesh Borundia authored
o Rename mac_learning to mac_override o Added check in set_mac to return error if mac override is disabled. o Disabling mac_override only supported for Non priviledged functions. Signed-off-by:
Rajesh Borundia <rajesh.borundia@qlogic.com> Signed-off-by:
-
Rajesh Borundia authored
o skb->mac_header is not set, so machine panics while using function eth_hdr. Signed-off-by:
-
Rajesh Borundia authored
o Allow enabling/disabling mac anti spoof policy only for Non privilege functions. Signed-off-by:
-
Rajesh Borundia authored
o Default eswitch config was set, even before eswitch capabilty get detected. As a result setting default config was getting fail. Signed-off-by:
-
Rajesh Borundia authored
o Mac addr was read from flash for every fw reset for Non-priviledge function.It should be read only once. o Remove unnecessary get_mac_addr callback Signed-off-by:
-
Rajesh Borundia authored
o ethtool reg version bumped to 2 Signed-off-by:
-
Sony Chacko authored
o Backing out "firmware initialization update" changes, commit-id "d4066833". o fix heartbit spelling, it should be heartbeat Signed-off-by:
Sony Chacko <sony.chacko@qlogic.com> Signed-off-by:
-
David S. Miller authored
drivers/net/stmmac/dwmac100_core.c: In function 'dwmac100_dump_mac_regs': drivers/net/stmmac/dwmac100_core.c:47: warning: cast from pointer to integer of different size Reported-by:
Stephen Rothwell <sfr@canb.auug.org.au> Signed-off-by:
-
- 31 Aug, 2010 8 commits
-
-
Eric Dumazet authored
tcp4_gro_receive() and tcp4_gro_complete() dont need to be exported. Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
Eric Dumazet authored
As some driver authors seem to reintroduce dev->last_rx use, add a comment to strongly discourage this. Since commit 6cf3f41e (bonding, net: Move last_rx update into bonding recv logic), network drivers dont need to update last_rx themselves, unless they use this field to implement a timeout. Not updating last_rx helps not dirtying a cache line, improving performance in SMP. Signed-off-by:
-
Eric Dumazet authored
remove non used variable "queue" in pg_cleanup Signed-off-by:
-
Jiri Pirko authored
[patch net-next-2.6] vlan: Use vlan_dev_real_dev in vlan_hwaccel_do_receive Use helper as in other places. Signed-off-by:
Jiri Pirko <jpirko@redhat.com> Signed-off-by:
-
Rémi Denis-Courmont authored
Signed-off-by:
Rémi Denis-Courmont <remi.denis-courmont@nokia.com> Signed-off-by:
-
Rémi Denis-Courmont authored
Signed-off-by:
-
Rémi Denis-Courmont authored
Signed-off-by:
-
David S. Miller authored
In file included from drivers/net/stmmac/stmmac_ethtool.c:30: drivers/net/stmmac/stmmac.h:111: warning: 'struct platform_device' declared inside parameter list drivers/net/stmmac/stmmac.h:111: warning: its scope is only this definition or declaration, which is probably not what you want drivers/net/stmmac/stmmac_main.c: In function 'stmmac_dvr_probe': drivers/net/stmmac/stmmac_main.c:1744: warning: cast from pointer to integer of different size In file included from drivers/net/stmmac/stmmac_mdio.c:31: drivers/net/stmmac/stmmac.h:111: warning: 'struct platform_device' declared inside parameter list drivers/net/stmmac/stmmac.h:111: warning: its scope is only this definition or declaration, which is probably not what you want drivers/net/stmmac/dwmac1000_core.c: In function 'dwmac1000_dump_regs': drivers/net/stmmac/dwmac1000_core.c:56: warning: cast from pointer to integer of different size Reported-by:
-
- 30 Aug, 2010 12 commits
-
-
Eric Dumazet authored
tunnel6_handlers chain being scanned for each incoming packet, make sure it doesnt share an often dirtied cache line. Signed-off-by:
-
Eric Dumazet authored
tunnel4_handlers chain being scanned for each incoming packet, make sure it doesnt share an often dirtied cache line. Signed-off-by:
-
Geert Uytterhoeven authored
resource_size_t changed from `unsigned long' to `phys_addr_t`, which is either `u32' or `u64'. Print the whole resource to remove the cast and to make it future-proof. Signed-off-by:
Geert Uytterhoeven <geert@linux-m68k.org> Signed-off-by:
-
Gerrit Renker authored
This updates the use of larger initial windows, as originally specified in RFC 3390, to use the newer IW values specified in RFC 5681, section 3.1. The changes made in RFC 5681 are: a) the setting now is more clearly specified in units of segments (as the comments by John Heffner emphasized, this was not very clear in RFC 3390); b) for connections with 1095 < SMSS <= 2190 there is now a change: - RFC 3390 says that IW <= 4380, - RFC 5681 says that IW = 3 * SMSS <= 6570. Since RFC 3390 is older and "only" proposed standard, whereas the newer RFC 5681 is already draft standard, it seems preferable to use the newer IW variant. Signed-off-by:Gerrit Renker <gerrit@erg.abdn.ac.uk> Signed-off-by:
-
Gerrit Renker authored
This makes RTAX_RTO_MIN also available to CCID-3, replacing the compile-time RTO lower bound with a per-route tunable value. The original Kconfig option solved the problem that a very low RTT (in the order of HZ) can trigger too frequent and unnecessary reductions of the sending rate. This tunable does not affect the initial RTO value of 2 seconds specified in RFC 5348, section 4.2 and Appendix B. But like the hardcoded Kconfig value, it allows to adapt to network conditions. The same effect as the original Kconfig option of 100ms is now achieved by > ip route replace to unicast 192.168.0.0/24 rto_min 100j dev eth0 (assuming HZ=1000). Signed-off-by:
-
Gerrit Renker authored
Using a fixed RTO_MIN of 0.2 seconds was found to cause problems for CCID-2 over 802.11g: at least once per session there was a spurious timeout. It helped to then increase the the value of RTO_MIN over this link. Since the problem is the same as in TCP, this patch makes the solution from commit "05bb1fad" "[TCP]: Allow minimum RTO to be configurable via routing metrics." available to DCCP. This avoids reinventing the wheel, so that e.g. the following works in the expected way now also for CCID-2: > ip route change 10.0.0.2 rto_min 800 dev ath0 Luckily this useful rto_min function was recently moved to net/tcp.h, which simplifies sharing code originating from TCP. Documentation also updated (plus minor whitespace fixes). Signed-off-by:
-
Gerrit Renker authored
This patch consolidates initial-window code common to TCP and CCID-2: * TCP uses RFC 3390 in a packet-oriented manner (tcp_input.c) and * CCID-2 uses RFC 3390 in packet-oriented manner (RFC 4341). Signed-off-by:
-
Gerrit Renker authored
This removes the wrappers around the sk timer functions, since not much is gained from using them: the BUG_ON in start_rto_timer will never trigger since that function is called only if: * the RTO timer expires (rto_expire, and then timer_pending() is false); * in tx_packet_sent only if !timer_pending() (BUG_ON is redundant here); * previously in new_ack, after stopping the timer (timer_pending() false). Removing the wrappers also clears the way for eventually replacing the RTO timer with the icsk-retransmission-timer, as it is already part of the DCCP socket. Signed-off-by:
-
Gerrit Renker authored
Since CCID-2 is de facto a mini implementation of TCP, it makes sense to share as much code as possible. Hence this patch aligns CCID-2 timestamping with TCP timestamping. This also halves the space consumption (on 64-bit systems). The necessary include file <net/tcp.h> is already included by way of net/dccp.h. Redundant includes have been removed. Signed-off-by:
-
Jerry Chu authored
This patch provides a "user timeout" support as described in RFC793. The socket option is also needed for the the local half of RFC5482 "TCP User Timeout Option". TCP_USER_TIMEOUT is a TCP level socket option that takes an unsigned int, when > 0, to specify the maximum amount of time in ms that transmitted data may remain unacknowledged before TCP will forcefully close the corresponding connection and return ETIMEDOUT to the application. If 0 is given, TCP will continue to use the system default. Increasing the user timeouts allows a TCP connection to survive extended periods without end-to-end connectivity. Decreasing the user timeouts allows applications to "fail fast" if so desired. Otherwise it may take upto 20 minutes with the current system defaults in a normal WAN environment. The socket option can be made during any state of a TCP connection, but is only effective during the synchronized states of a connection (ESTABLISHED, FIN-WAIT-1, FIN-WAIT-2, CLOSE-WAIT, CLOSING, or LAST-ACK). Moreover, when used with the TCP keepalive (SO_KEEPALIVE) option, TCP_USER_TIMEOUT will overtake keepalive to determine when to close a connection due to keepalive failure. The option does not change in anyway when TCP retransmits a packet, nor when a keepalive probe will be sent. This option, like many others, will be inherited by an acceptor from its listener. Signed-off-by:
H.K. Jerry Chu <hkchu@google.com> Signed-off-by:
-
Simon Horman authored
Signed-off-by:
Simon Horman <horms@verge.net.au> Signed-off-by:
-
Stephen Rothwell authored
Fixes this build error: net/netfilter/ipvs/ip_vs_core.c: In function 'ip_vs_nat_icmp_v6': net/netfilter/ipvs/ip_vs_core.c:640: error: implicit declaration of function 'csum_ipv6_magic' Signed-off-by:
-
- 28 Aug, 2010 7 commits
-
-
Julia Lawall authored
The nic_type field is compared to athr_l2c twice. The sematic match that finds this problem is as follows: (http://coccinelle.lip6.fr/) // <smpl> @expression@ expression E; @@ ( * E || ... || E | * E && ... && E ) // </smpl> Signed-off-by:
Julia Lawall <julia@diku.dk> Signed-off-by:
-
Akinobu Mita authored
Detect size mismatch for netdrv_addr_t at build time rather than checking at module load time. Signed-off-by:
Akinobu Mita <akinobu.mita@gmail.com> Cc: Ion Badulescu <ionut@badula.org> Cc: "David S. Miller" <davem@davemloft.net> Cc: netdev@vger.kernel.org Signed-off-by:
-
Akinobu Mita authored
Signed-off-by:
-
Akinobu Mita authored
Replace open-coded loop with for_each_set_bit(). Signed-off-by:
-
Akinobu Mita authored
Replace loops calling set_bit() and clear_bit() with bitmap_set() and bitmap_clear(). Unlike loops calling set_bit() and clear_bit(), bitmap_set() and bitmap_clear() are not atomic. But this is ok. Because the bitmap operations are protected by bitmap->lock except for initialization of the bitmap in mlx4_bitmap_init(). Signed-off-by:
-
Akinobu Mita authored
The spinlock aun_queue_lock is initialized statically. It is unnecessary to initialize by spin_lock_init() at module load time. This is detected by the semantic patch. // <smpl> @def@ declarer name DEFINE_SPINLOCK; identifier spinlock; @@ DEFINE_SPINLOCK(spinlock); @@ identifier def.spinlock; @@ - spin_lock_init(&spinlock); // </smpl> Signed-off-by:
-
Tobias Klauser authored
Use net_device->stats for stats instead of private variable copies in struct slip. Use ndo_get_stat64 so the additions can be performed on a private destination buffer. Cc: Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
Tobias Klauser <tklauser@distanz.ch> Acked-by:
-
