Removed barrier - it is not an ext2 option.

Corrected the distinction between kernel-selected defaults and values
read from the filesystem.

Fixed some typos.  Shortened line length to 80.

This implements support for doing a HW synchronization of the CPU
timebases on SMP G5 machines.

 When the proper clock chips are found on i2c, they are used to stop the
timebase clock source during the synchronization process.  This replaces
the software sync algorithm we used so far and provides slightly more
precise results.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The code in pmac_low_i2c.c is a low level synchronous version of the i2c keywest
driver for use by platform code early during boot or during sleep/wakeup cycles
to communicate with some motherboard chips, typically clock chips.
It wasn't used on g5 until now, which is good because it wasn't 64 bits clean :)

This patch fixes it, and also remove the use of udelay() since it can be used for
synchronizing the HW timebase, and so must operate when it's frozen (and our
implementation of udelay uses that timebase).
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Thanks to Kay Sievers for reporting this. 

Was caused by a change from Venkatesh Pallipadi as seen at:
  http://linux.bkbits.net:8080/linux-2.5/cset@41810e4aGZ0E5bn_hMb4JgIY5u90zASigned-off-by: Greg Kroah-Hartman <greg@kroah.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

EFI partitioning scheme was reading the last reported sector of the
block device to look for the alternate GPT header, before it had
confirmed that it should.  This causes problems for devices with the
following problems:  a) those who misreport their size (typically
off-by-one), and b) those who fail when asked to read a block
outside their range.

This patch moves the test for the Protective Master Boot Record (PMBR)
ahead of the tests for the Primary and Alternate GPT headers.  If the
PMBR is not valid, the disk is assumed to not be a GPT disk.  This can
be overridden with the 'gpt' kernel command line option.  If the
Primary GPT header is not valid, the Alternate GPT header is not
probed automatically unless the 'gpt' kernel command line option is
passed.  If the both the PMBR and Primary GPT header are valid, then
the Alternate GPT header at the end of the disk is probed.

Also re-enables CONFIG_EFI_PARTITION for all architectures.
Signed-off-by: Matt Domsch <Matt_Domsch@dell.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This fixes a problem introduced in the previous set of driver model
changes that has been seen by a lot of people (most notibly the greater
than 256 pty users, but others might also be hitting this without
realizing it.)

Also add a comment so we don't try to "fix" this again.
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into intel.com:/home/lenb/src/26-latest-dev

into intel.com:/home/lenb/src/26-latest-dev

Signed-off-by: Len Brown <len.brown@intel.com>

into intel.com:/home/lenb/src/26-latest-dev

into ppc970.osdl.org:/home/torvalds/v2.6/linux

If you call drivers/md/dm-io.c:resize_pool on an empty pool and
mempool_create is unable to make the pool, the condition is not handled
correctly, resulting in an oops in mempool_destroy.

Trivial fix.

Minor changes required to port kprobes for sparc64.

- arch_prepare_kprobe() returns an integer.

- added arch_remove_kprobe().

- changes to access copy of original instruction, since kprobe_opcode_t
  insn[MAX_INSN_SIZE] is moved from struct kprobe to a struct
  arch_specific_insn.
Signed-off-by: Prasanna S Panchamukhi <prasanna@in.ibm.com>
Cc: "David S. Miller" <davem@davemloft.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

released the tasklist_lock.

Since it released the lock, the process lists may not
be valid any more, and we must repeat the loop rather than
continue with the next parent.

Use -EAGAIN to show this condition (separate from the
normal -EFAULT that may happen if rusage information could
not be copied to user space).

into kroah.com:/home/greg/linux/BK/i2c-2.6

Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

This patch integrates several fixes to the s3c2410 i2c
driver

Shannon Holland:

	- write IICCON in configuration code
	- add handling for s3c2410 i2c errata
	- fix clock rate divisor calculation

Ben Dooks:

	- s3c2440 detection
	- s3c2440 IICLC register setup
	- add __exit to the module exit
	- remove return from exit code
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Shannon Holland <holland@loser.net>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The patch below makes some needlessly global code under i2c/busses/
static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The patch adds a check at the beginning of i2c_del_adapter in case
someone attempts to remove an adapter that was never added in the first
place. This sounds like a good safety, as doing so will lead to an oops
at the moment. Also, I have a need for it in the latest version of my
i2c-amd756-s4882 patch. I need to remove the original adapter and
install the virtual ones instead, but I have no way to know if the
original adapter was succesfully added beforehand or not.
Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Justin Thiessen <jthiessen@penguincomputing.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

In big endian machines, the read*/write* accessors do a byteswap for an
inherently little endian PCI bus.  However, rivafb puts the hardwire in big
endian register access, thus the byteswap is not needed. So for 16- and
32-bit access, instead of read*/write*, use __raw_read*/__raw_write* for all
archs.
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into bkbits.net:/repos/j/jfs/linux-2.5

Typo introduced by latest cleanups by Antonino

At unload i8042 sets panic_blink to 0.  This will cause problems if kernel
panics later as it will just use it assuming that the pointer is correct.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The patch below fixes two flaws in minix_clear_inode.

The first is that it tests bh which is never initialized.  (&bh is a
parameter of minix_V1_raw_inode, but that routine can fail and return
before it has set bh)

The second is that generic_delete_inode() goes BUG() in case inode->i_state
!= I_CLEAR.  Clearly, it is expected that inode->i_sb->s_op->delete_inode
does a clear_inode() at some point.  But minix_delete_inode() calls
minix_free_inode() and that routine can print an error and return early,
before calling clear_inode().
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Peter Osterlund <petero2@telia.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

ppdev's ioctls are not available for 32bit apps on 64bit systems.  There
are four ioctls which take no argument at all (so they are compatible
between 32bit and 64bit), these numbers do not clash with any other ioctl
code, and so I see no reason why not applying patch below.

It solves problem VMware users are faced on 64bit systems if they want to
use direct access to the parallel port.
Signed-off-by: Petr Vandrovec <vandrove@vc.cvut.cz>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Although it was checking the per-character error flags supplied by the
driver for ordinary characters, the ppp_async line discipline code wasn't
checking the flags for special characters, such as the flag and escape
characters (~ and }).  This patch adds that check.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

ia64 and ppc64 have function descriptors.  Booting with initcall_debug will
print the descriptor address, not the address and name of the actual
function.  Another indirection is required.

Tested on ppc, ppc64 and ia64.
Signed-off-by: Olaf Hering <olh@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>