backlight: pwm_bl: Don't assign levels table repeatedly

pwm_backlight_probe() re-assigns pb->levels for every brightness
level. This is not needed and was likely not intended, since
neither side of the assignment changes during the loop. Assign
the field only once.
Signed-off-by: Matthias Kaehlcke <mka@chromium.org>
Reviewed-by: Daniel Thompson <daniel.thompson@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

drivers/video/backlight/pwm_bl.c

@@ -564,18 +564,17 @@ static int pwm_backlight_probe(struct platform_device *pdev)
 	memset(&props, 0, sizeof(struct backlight_properties));
 
 	if (data->levels) {
+		pb->levels = data->levels;
+
 		/*
 		 * For the DT case, only when brightness levels is defined
 		 * data->levels is filled. For the non-DT case, data->levels
 		 * can come from platform data, however is not usual.
 		 */
-		for (i = 0; i <= data->max_brightness; i++) {
+		for (i = 0; i <= data->max_brightness; i++)
 			if (data->levels[i] > pb->scale)
 				pb->scale = data->levels[i];
 
-			pb->levels = data->levels;
-		}
-
 		if (pwm_backlight_is_linear(data))
 			props.scale = BACKLIGHT_SCALE_LINEAR;
 		else