-
Markus Hofstaetter authored
Some PWMs are disabled by default or the default pin setting does not match the LED_OFF state (e.g., active-low leds). Hence, the driver may end up reporting 0 brightness, but the leds are actually on using full brightness, because it never enforces its default configuration. So enforce it by calling led_pwm_set() after successfully registering the device. Tested on a Phytec phyFLEX i.MX6Q board based on kernel v3.19.5. Signed-off-by:
Markus Hofstaetter <markus.hofstaetter@ait.ac.at> Tested-by:
Markus Hofstaetter <markus.hofstaetter@ait.ac.at> Signed-off-by:
Jacek Anaszewski <j.anaszewski@samsung.com>
f1670336