mtd: nand: qcom: fix config error for BCH

commit 10777de5 upstream.

The configuration for BCH is not correct in the current driver.
The ECC_CFG_ECC_DISABLE bit defines whether to enable or disable the
BCH ECC in which

	0x1 : BCH_DISABLED
	0x0 : BCH_ENABLED

But currently host->bch_enabled is being assigned to BCH_DISABLED.

Fixes: c76b78d8 ("mtd: nand: Qualcomm NAND controller driver")
Signed-off-by: Abhishek Sahu <absahu@codeaurora.org>
Reviewed-by: Archit Taneja <architt@codeaurora.org>
Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/mtd/nand/qcom_nandc.c

@@ -1900,7 +1900,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host)
 				| wide_bus << WIDE_FLASH
 				| 1 << DEV0_CFG1_ECC_DISABLE;
 
-	host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE
+	host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE
 				| 0 << ECC_SW_RESET
 				| host->cw_data << ECC_NUM_DATA_BYTES
 				| 1 << ECC_FORCE_CLK_OPEN