Commit 10ad91f5 authored by Ulf Hansson's avatar Ulf Hansson Committed by Luis Henriques

ARM: ux500: Move GPIO regulator for SD-card into board DTSs

commit 53d26698 upstream.

The GPIO regulator for the SD-card isn't a ux500 SOC configuration, but
instead it's specific to the board. Move the definition of it, into the
board DTSs.

Fixes: c94a4ab7 ("ARM: ux500: Disable the MMCI gpio-regulator by default")
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
Reviewed-by: default avatarBjorn Andersson <bjorn.andersson@sonymobile.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: default avatarLuis Henriques <luis.henriques@canonical.com>
parent 63d525e6
......@@ -985,23 +985,6 @@ cpufreq-cooling {
status = "disabled";
};
vmmci: regulator-gpio {
compatible = "regulator-gpio";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <2900000>;
regulator-name = "mmci-reg";
regulator-type = "voltage";
startup-delay-us = <100>;
enable-active-high;
states = <1800000 0x1
2900000 0x0>;
status = "disabled";
};
mcde@a0350000 {
compatible = "stericsson,mcde";
reg = <0xa0350000 0x1000>, /* MCDE */
......
......@@ -111,6 +111,23 @@ i2c@80110000 {
pinctrl-1 = <&i2c3_sleep_mode>;
};
vmmci: regulator-gpio {
compatible = "regulator-gpio";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <2900000>;
regulator-name = "mmci-reg";
regulator-type = "voltage";
startup-delay-us = <100>;
enable-active-high;
states = <1800000 0x1
2900000 0x0>;
status = "disabled";
};
// External Micro SD slot
sdi0_per1@80126000 {
arm,primecell-periphid = <0x10480180>;
......
......@@ -147,8 +147,23 @@ ethernet@0 {
};
vmmci: regulator-gpio {
compatible = "regulator-gpio";
gpios = <&gpio7 4 0x4>;
enable-gpio = <&gpio6 25 0x4>;
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <2900000>;
regulator-name = "mmci-reg";
regulator-type = "voltage";
startup-delay-us = <100>;
enable-active-high;
states = <1800000 0x1
2900000 0x0>;
status = "disabled";
};
// External Micro SD slot
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment