ARM: ux500: Move GPIO regulator for SD-card into board DTSs

The GPIO regulator for the SD-card isn't a ux500 SOC configuration, but
instead it's specific to the board. Move the definition of it, into the
board DTSs.

Fixes: c94a4ab7 ("ARM: ux500: Disable the MMCI gpio-regulator by default")
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/boot/dts/ste-dbx5x0.dtsi

@@ -1017,23 +1017,6 @@ cpufreq-cooling {
 			status = "disabled";
 		};
 
-		vmmci: regulator-gpio {
-			compatible = "regulator-gpio";
-
-			regulator-min-microvolt = <1800000>;
-			regulator-max-microvolt = <2900000>;
-			regulator-name = "mmci-reg";
-			regulator-type = "voltage";
-
-			startup-delay-us = <100>;
-			enable-active-high;
-
-			states = <1800000 0x1
-				  2900000 0x0>;
-
-			status = "disabled";
-		};
-
 		mcde@a0350000 {
 			compatible = "stericsson,mcde";
 			reg = <0xa0350000 0x1000>, /* MCDE */

arch/arm/boot/dts/ste-href.dtsi

@@ -111,6 +111,23 @@ i2c@80110000 {
 			pinctrl-1 = <&i2c3_sleep_mode>;
 		};
 
+		vmmci: regulator-gpio {
+			compatible = "regulator-gpio";
+
+			regulator-min-microvolt = <1800000>;
+			regulator-max-microvolt = <2900000>;
+			regulator-name = "mmci-reg";
+			regulator-type = "voltage";
+
+			startup-delay-us = <100>;
+			enable-active-high;
+
+			states = <1800000 0x1
+				  2900000 0x0>;
+
+			status = "disabled";
+		};
+
 		// External Micro SD slot
 		sdi0_per1@80126000 {
 			arm,primecell-periphid = <0x10480180>;

arch/arm/boot/dts/ste-snowball.dts

@@ -146,8 +146,23 @@ ethernet@0 {
 		};
 
 		vmmci: regulator-gpio {
+			compatible = "regulator-gpio";
+
 			gpios = <&gpio7 4 0x4>;
 			enable-gpio = <&gpio6 25 0x4>;
+
+			regulator-min-microvolt = <1800000>;
+			regulator-max-microvolt = <2900000>;
+			regulator-name = "mmci-reg";
+			regulator-type = "voltage";
+
+			startup-delay-us = <100>;
+			enable-active-high;
+
+			states = <1800000 0x1
+				  2900000 0x0>;
+
+			status = "disabled";
 		};
 
 		// External Micro SD slot