arm64: dts: uniphier: Add USB2 PHY nodes

Add nodes of USB2 physical layer for UniPhier SoC. This supports LD11.
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

arch/arm64/boot/dts/socionext/uniphier-ld11.dtsi

@@ -454,6 +454,8 @@ usb0: usb@5a800100 {
 				 <&mio_clk 12>;
 			resets = <&sys_rst 8>, <&mio_rst 7>, <&mio_rst 8>,
 				 <&mio_rst 12>;
+			phy-names = "usb";
+			phys = <&usb_phy0>;
 			has-transaction-translator;
 		};
 
@@ -468,6 +470,8 @@ usb1: usb@5a810100 {
 				 <&mio_clk 13>;
 			resets = <&sys_rst 8>, <&mio_rst 7>, <&mio_rst 9>,
 				 <&mio_rst 13>;
+			phy-names = "usb";
+			phys = <&usb_phy1>;
 			has-transaction-translator;
 		};
 
@@ -482,6 +486,8 @@ usb2: usb@5a820100 {
 				 <&mio_clk 14>;
 			resets = <&sys_rst 8>, <&mio_rst 7>, <&mio_rst 10>,
 				 <&mio_rst 14>;
+			phy-names = "usb";
+			phys = <&usb_phy2>;
 			has-transaction-translator;
 		};
 
@@ -510,6 +516,27 @@ soc_glue: soc-glue@5f800000 {
 			pinctrl: pinctrl {
 				compatible = "socionext,uniphier-ld11-pinctrl";
 			};
+
+			usb-phy {
+				compatible = "socionext,uniphier-ld11-usb2-phy";
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				usb_phy0: phy@0 {
+					reg = <0>;
+					#phy-cells = <0>;
+				};
+
+				usb_phy1: phy@1 {
+					reg = <1>;
+					#phy-cells = <0>;
+				};
+
+				usb_phy2: phy@2 {
+					reg = <2>;
+					#phy-cells = <0>;
+				};
+			};
 		};
 
 		soc-glue@5f900000 {