MIPS: sibyte: Remove Sibyte CARMEL and CRHINE board support

Looks like these boards were nether in active use, so let's remove them.
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>

arch/mips/Kconfig

@@ -794,24 +794,6 @@ config SGI_IP32
 	help
 	  If you want this kernel to run on SGI O2 workstation, say Y here.
 
-config SIBYTE_CRHINE
-	bool "Sibyte BCM91120C-CRhine"
-	select BOOT_ELF32
-	select SIBYTE_BCM1120
-	select SWAP_IO_SPACE
-	select SYS_HAS_CPU_SB1
-	select SYS_SUPPORTS_BIG_ENDIAN
-	select SYS_SUPPORTS_LITTLE_ENDIAN
-
-config SIBYTE_CARMEL
-	bool "Sibyte BCM91120x-Carmel"
-	select BOOT_ELF32
-	select SIBYTE_BCM1120
-	select SWAP_IO_SPACE
-	select SYS_HAS_CPU_SB1
-	select SYS_SUPPORTS_BIG_ENDIAN
-	select SYS_SUPPORTS_LITTLE_ENDIAN
-
 config SIBYTE_CRHONE
 	bool "Sibyte BCM91125C-CRhone"
 	select BOOT_ELF32

arch/mips/include/asm/sibyte/board.h

@@ -7,7 +7,7 @@
 #define _SIBYTE_BOARD_H
 
 #if defined(CONFIG_SIBYTE_SWARM) || defined(CONFIG_SIBYTE_CRHONE) || \
-    defined(CONFIG_SIBYTE_CRHINE) || defined(CONFIG_SIBYTE_LITTLESUR)
+    defined(CONFIG_SIBYTE_LITTLESUR)
 #include <asm/sibyte/swarm.h>
 #endif
 
@@ -15,10 +15,6 @@
 #include <asm/sibyte/sentosa.h>
 #endif
 
-#ifdef CONFIG_SIBYTE_CARMEL
-#include <asm/sibyte/carmel.h>
-#endif
-
 #ifdef CONFIG_SIBYTE_BIGSUR
 #include <asm/sibyte/bigsur.h>
 #endif

arch/mips/include/asm/sibyte/carmel.h

-/* SPDX-License-Identifier: GPL-2.0-or-later */
-/*
- * Copyright (C) 2002 Broadcom Corporation
- */
-#ifndef __ASM_SIBYTE_CARMEL_H
-#define __ASM_SIBYTE_CARMEL_H
-
-#include <asm/sibyte/sb1250.h>
-#include <asm/sibyte/sb1250_int.h>
-
-#define SIBYTE_BOARD_NAME "Carmel"
-
-#define GPIO_PHY_INTERRUPT	2
-#define GPIO_NONMASKABLE_INT	3
-#define GPIO_CF_INSERTED	6
-#define GPIO_MONTEREY_RESET	7
-#define GPIO_QUADUART_INT	8
-#define GPIO_CF_INT		9
-#define GPIO_FPGA_CCLK		10
-#define GPIO_FPGA_DOUT		11
-#define GPIO_FPGA_DIN		12
-#define GPIO_FPGA_PGM		13
-#define GPIO_FPGA_DONE		14
-#define GPIO_FPGA_INIT		15
-
-#define LEDS_CS			2
-#define LEDS_PHYS		0x100C0000
-#define MLEDS_CS		3
-#define MLEDS_PHYS		0x100A0000
-#define UART_CS			4
-#define UART_PHYS		0x100D0000
-#define ARAVALI_CS		5
-#define ARAVALI_PHYS		0x11000000
-#define IDE_CS			6
-#define IDE_PHYS		0x100B0000
-#define ARAVALI2_CS		7
-#define ARAVALI2_PHYS		0x100E0000
-
-#if defined(CONFIG_SIBYTE_CARMEL)
-#define K_GPIO_GB_IDE	9
-#define K_INT_GB_IDE	(K_INT_GPIO_0 + K_GPIO_GB_IDE)
-#endif
-
-
-#endif /* __ASM_SIBYTE_CARMEL_H */

arch/mips/include/asm/sibyte/swarm.h

@@ -24,11 +24,6 @@
 #define SIBYTE_HAVE_PCMCIA 0
 #define SIBYTE_HAVE_IDE	   0
 #endif
-#ifdef CONFIG_SIBYTE_CRHINE
-#define SIBYTE_BOARD_NAME "BCM91120C (CRhine)"
-#define SIBYTE_HAVE_PCMCIA 0
-#define SIBYTE_HAVE_IDE	   0
-#endif
 
 /* Generic bus chip selects */
 #define LEDS_CS		3

arch/mips/sibyte/Kconfig

@@ -10,15 +10,6 @@ config SIBYTE_SB1250
 	select SIBYTE_SB1xxx_SOC
 	select SYS_SUPPORTS_SMP
 
-config SIBYTE_BCM1120
-	bool
-	select CEVT_SB1250
-	select CSRC_SB1250
-	select IRQ_MIPS_CPU
-	select SIBYTE_BCM112X
-	select SIBYTE_HAS_ZBUS_PROFILING
-	select SIBYTE_SB1xxx_SOC
-
 config SIBYTE_BCM1125
 	bool
 	select CEVT_SB1250

arch/mips/sibyte/Makefile

@@ -10,15 +10,11 @@ obj-$(CONFIG_SIBYTE_BCM1x80)	+= bcm1480/
 obj-$(CONFIG_SIBYTE_BCM1x80)	+= common/
 
 #
-# Sibyte BCM91120x (Carmel) board
-# Sibyte BCM91120C (CRhine) board
 # Sibyte BCM91125C (CRhone) board
 # Sibyte BCM91125E (Rhone) board
 # Sibyte SWARM board
 # Sibyte BCM91x80 (BigSur) board
 #
-obj-$(CONFIG_SIBYTE_CARMEL)	+= swarm/
-obj-$(CONFIG_SIBYTE_CRHINE)	+= swarm/
 obj-$(CONFIG_SIBYTE_CRHONE)	+= swarm/
 obj-$(CONFIG_SIBYTE_RHONE)	+= swarm/
 obj-$(CONFIG_SIBYTE_SENTOSA)	+= swarm/

arch/mips/sibyte/Platform

@@ -18,16 +18,12 @@ cflags-$(CONFIG_SIBYTE_BCM1x80) +=					\
 		-DSIBYTE_HDR_FEATURES=SIBYTE_HDR_FMASK_1480_ALL
 
 #
-# Sibyte BCM91120x (Carmel) board
-# Sibyte BCM91120C (CRhine) board
 # Sibyte BCM91125C (CRhone) board
 # Sibyte BCM91125E (Rhone) board
 # Sibyte BCM91250A (SWARM) board
 # Sibyte BCM91250C2 (LittleSur) board
 # Sibyte BCM91x80 (BigSur) board
 #
-load-$(CONFIG_SIBYTE_CARMEL)	:= 0xffffffff80100000
-load-$(CONFIG_SIBYTE_CRHINE)	:= 0xffffffff80100000
 load-$(CONFIG_SIBYTE_CRHONE)	:= 0xffffffff80100000
 load-$(CONFIG_SIBYTE_RHONE)	:= 0xffffffff80100000
 load-$(CONFIG_SIBYTE_SENTOSA)	:= 0xffffffff80100000

arch/mips/sibyte/swarm/setup.c

@@ -146,12 +146,6 @@ void __init plat_mem_setup(void)
 
 #ifdef LEDS_PHYS
 
-#ifdef CONFIG_SIBYTE_CARMEL
-/* XXXKW need to detect Monterey/LittleSur/etc */
-#undef LEDS_PHYS
-#define LEDS_PHYS MLEDS_PHYS
-#endif
-
 void setleds(char *str)
 {
 	void *reg;