into ppc970.osdl.org:/home/torvalds/v2.6/linux

This is the second of 4 patches which factor out common code in
the ARM exception entry assembly code, aiming towards a reduction
in the size of the changes required here for SMP support.  These
patches are low impact, and will be merged over the coarse of the
next 3 days.

This patch addresses the code handling exception entry from
invalid (irq, fiq, abort) modes.  However, in converting to a
macro, a minor bug has been fixed which would merely cause a
misleading register dump.

Yet another accounting bug, this time hits on requeue. It is possible
for ->accounted to be set with ->in_flight, so don't nest the
cfq_account_completion() inside the ->in_flight check.
Signed-off-by: Jens Axboe <axboe@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Handle empty nodes in SRAT parsing. Avoids an oops at boot time.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Fix bug in change_page_attr - with multiple pages it would not flush
correctly. Also add a small optimization of not flushing when not needed.

Found and fixed by Andrea. 
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Document atkbd.softraw (and shorten a few long lines nearby).

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Added support for the ICH4-M, ICH6, ICH6R, ICH6-M, ICH6W and ICH6RW
chipsets. Also added support for the "undocumented" ICH7.

This is the first of 4 patches which factor out common code in
the ARM exception entry assembly code, aiming towards a reduction
in the size of the changes required here for SMP support.  These
patches are low impact, and will be merged over the coarse of the
next 4 days.

This patch addresses the code handling exception entry from
supervisor (kernel) mode.

Patch from Marc Singer

The special case for the Sharp LH processors is unnecessary.  A macro
override makes it cleaner and concentrates the change where it ought
to be.  The default in include/asm-arm/numnodes.h means that only
platforms that care to change the default need to do anything.

Signed-off-by: Marc Singer
Signed-off-by: Russell King

Patch from Ben Dooks

Patch from Shannon Holland
Enable automatic flow control if requested.

Signed-off-by: Shannon Holland

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Patch from Dimitry Andric.
The s3c2410 serial driver selects the opposite parity
mode if parity is enabled.

Signed-off-by: Dimitry Andric

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Ben Dooks

Patch from Dimitry Andric.
The include/asm-arm/arch-s3c2410/io.h file converts
PC style port addresses to real ARM addresses, and
needs to return an `void __iomem *` to avoid a number
of warnings:
  CC      drivers/ide/ide-iops.o
drivers/ide/ide-iops.c: In function `ide_insw':
drivers/ide/ide-iops.c:49: warning: passing arg 1 of `__raw_readsw' makes pointer from integer without a cast
drivers/ide/ide-iops.c: In function `ide_insl':
drivers/ide/ide-iops.c:59: warning: passing arg 1 of `__raw_readsl' makes pointer from integer without a cast
drivers/ide/ide-iops.c: In function `ide_outsw':
drivers/ide/ide-iops.c:79: warning: passing arg 1 of `__raw_writesw' makes pointer from integer without a cast
drivers/ide/ide-iops.c: In function `ide_outsl':
drivers/ide/ide-iops.c:89: warning: passing arg 1 of `__raw_writesl' makes pointer from integer without a cast
  CC      lib/iomap.o
lib/iomap.c: In function `ioread8_rep':
lib/iomap.c:140: warning: passing arg 1 of `__raw_readsb' makes pointer from integer without a cast
lib/iomap.c: In function `ioread16_rep':
lib/iomap.c:144: warning: passing arg 1 of `__raw_readsw' makes pointer from integer without a cast
lib/iomap.c: In function `ioread32_rep':
lib/iomap.c:148: warning: passing arg 1 of `__raw_readsl' makes pointer from integer without a cast
lib/iomap.c: In function `iowrite8_rep':
lib/iomap.c:156: warning: passing arg 1 of `__raw_writesb' makes pointer from integer without a cast
lib/iomap.c: In function `iowrite16_rep':
lib/iomap.c:160: warning: passing arg 1 of `__raw_writesw' makes pointer from integer without a cast
lib/iomap.c: In function `iowrite32_rep':
lib/iomap.c:164: warning: passing arg 1 of `__raw_writesl' makes pointer from integer without a cast

Signed-off-by: Dimitry Andric

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Patch from David Vrabel

Use some #define'd constants in the ixp4xx's arch_reset().

Signed-off-by: David Vrabel
Signed-off-by: Russell King

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

Signed-off-by: Russell King <rmk@arm.linux.org.uk>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Use netdev_priv() and get rid of the PRIV() macro by using the correct
data element. Also eliminate casts, where type is correct.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

When the skfddi driver was converted to the new PCI netdevice interface,
it never got tested with real hardware. The initialization got broken, this
should fix it.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Fixes instances where gfar_read() was invoked in debug codewith a value,
rather than a pointer.
Signed-of-by: Andy Fleming <afleming@freescale.com>
Signed-of-by: Kumar Gala <afleming@freescale.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

From: Steven Rostedt <rostedt@goodmis.org>

If the transmit buffer of the e100 overflowed, then the system would hang.
This was caused because the e100 driver would stop the queue, and
netpoll_send_pkt in netpoll.c would then loop forever.  This is because the
e100 net_poll would never start the queue again after the transmits have
completed.

For those that use the e100 and netconsole, all you need to do is a sysreq
't' to lock up the system.
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Fixes breakage in getting MAC address on built-in tulip in
alphastation 200 - without delay we are skipping bytes.
Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

This patch adds the Intel ICH7R DID's to the ahci.c SATA AHCI driver
for ICH7R SATA support.
Signed-off-by:  Jason Gaston <Jason.d.gaston@intel.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into silver.ucw.cz:/home/vojtech/bk/dmitry

Signed-off-by: Vojtech Pavlik <vojtech@suse.cz>

       changing HID->event mappings (via EVIOCS*) in the future and make 
       debugging easier now.
Signed-off-by: Vojtech Pavlik <vojtech@suse.cz>

       rebooting.
Signed-off-by: Vojtech Pavlik <vojtech@suse.cz>

       good idea to discard any character other than ACK/NAK during probe
       it causes missing releases and keys getting "stuck" when a command
       issued on enabled device. The effect is easily demonstrated with
       the following command:
           while true; do xset led 3; xset -led 3; done

       With this change extra characters will be discarded only if device
       has not been marked as "enabled" yet.

Signed-off-by: Dmitry Torokhov <dtor@mail.ru> 

into silver.ucw.cz:/home/vojtech/bk/input

looking at ext3_xattr_block_set() [fs/ext3/xattr.c] ...
I see that

                                error = -EDQUOT;
                                if (DQUOT_ALLOC_BLOCK(inode, 1))
                                        goto cleanup;

allocates a quota block, but right after that several
error echecks happen ...

                                if (error)
                                        goto cleanup;

and I don't see any DQUOT_FREE_BLOCK() in the errorpath

cleanup:
        if (ce)
                mb_cache_entry_release(ce);
        brelse(new_bh); 
        if (!(bs->bh && s->base == bs->bh->b_data))
                kfree(s->base);

        return error;

I'd suggest the attached fix.
Acked-by: Jan Kara <jack@suse.cz>
Acked-by: Andreas Gruenbacher <agruen@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Patch from Nicolas Pitre

This enables audio on Mainstone with the ALSA PXA2xx AC97 driver.

Signed-off-by: Nicolas Pitre
Signed-off-by: Russell King

Patch from Ben Dooks

All the headers refer to debug-armv.S, when they where split from
debug.S

Signed-off-by: Ben Dooks
Signed-off-by: Russell King